Author Topic: Small Arms  (Read 7759 times)

Offline Rickshaw

  • "Of course, I could be talking out of my hat"
Small Arms
« on: June 27, 2014, 08:51:42 PM »
Re the SLR, wasn't it also converted to imperial measurements from metric, and although some parts were interchangeable, quite a lot wern't?


As was the L2A1 AR (Automatic Rifle) which also had the auto safety and heavy barrel.  Always thought an AR with a conventional fore stock would have been a good thing.  It was a mean looking weapon but my experience of a triple feed and jam on the range did temper my view of them.  I often carried one as No.2 on the gun in my Uni Regiment days, the idea being that in the event of a major stoppage on the M-60 the No.1 and Section 2IC would fix the gun and I would provide suppressive fire with the AR.

Is this getting to the point that its worth splitting off into a separate topic on FN FALs and derivatives?


Yes.

The L2a1 was a copy of the Canadian C2a1, without the C2's dust cover which allowed loading of the magazine with stripper clips, without having to remove it first.

L2a1:


C2a1:


L2s were pretty much exclusively an ARes weapon, although they were originally intended for use by Armoured troopers but the Regulars after they realised how bad the weapon was, pretty well abandoned it.   Its major problem was that it was prone to stoppages and misfeeds from fouling of the gas system unless it was kept scrupulously clean. I used to fire the L2a1 on various ARes exercises.  I much preferred the L4a4 Bren personally as an LMG.  Much more reliable.  Both suffered from the lack of a proper foregrip though and I've burnt my hand on both of them at various times.  It was always bloody inconvenient having a bare barrel just where you were likely to grab the weapon when getting up off the ground.

For diggers who liked to look "warry" the 30 round magazine was a favourite as it would fit the standard L1a1, although it made it rather front heavy.  Both pictures show the earlier straight 30 round magazine.  It was later replaced with a slightly curved one because they found it fed better.   The 30 round magazine was also used on the L4a4 Bren.
« Last Edit: June 27, 2014, 10:07:01 PM by Rickshaw »

Offline ysi_maniac

  • I will die understanding not this world
Re: Small Arms
« Reply #1 on: February 08, 2016, 08:21:47 PM »
What if a 12.70 mm version of MG-42


Offline jcf

  • Global Moderator
  • Turn that Gila-copter down!
Re: Small Arms
« Reply #2 on: February 09, 2016, 02:39:55 AM »
Or perhaps an infantry version of the MG 131?
https://en.wikipedia.org/wiki/MG_131_machine_gun

"Evil our grandsires were, our fathers worse;
And we, till now unmatched in ill,
Must leave successors more corrupted still."
Horace, 65BC - 8BC. Marsh translation.

Offline GTX_Admin

  • Evil Administrator bent on taking over the Universe!
  • Administrator - Yep, I'm the one to blame for this place.
  • Whiffing Demi-God!
    • Beyond the Sprues
Re: Small Arms
« Reply #3 on: February 09, 2016, 03:24:10 AM »
Or perhaps an infantry version of the MG 131?
https://en.wikipedia.org/wiki/MG_131_machine_gun


Something like these perhaps?

All hail the God of Frustration!!!

Offline jcf

  • Global Moderator
  • Turn that Gila-copter down!
Re: Small Arms
« Reply #4 on: February 09, 2016, 03:50:49 AM »
Nope, a proper redesign for the infantry role, rather than the extemporized
emergency measure version.
"Evil our grandsires were, our fathers worse;
And we, till now unmatched in ill,
Must leave successors more corrupted still."
Horace, 65BC - 8BC. Marsh translation.

Offline Dr. YoKai

  • Was in High School when mastadons roamed the plains...
  • A notorious curmudgeon who is partial to...hemp!
Re: Small Arms
« Reply #5 on: February 14, 2016, 12:51:32 AM »
 or perhaps a further development of the abandoned TuF MG?

Offline ysi_maniac

  • I will die understanding not this world
Re: Small Arms
« Reply #6 on: February 14, 2016, 01:03:19 AM »

Offline ysi_maniac

  • I will die understanding not this world
Re: Small Arms
« Reply #7 on: February 20, 2016, 06:43:58 PM »

Offline jcf

  • Global Moderator
  • Turn that Gila-copter down!
Re: Small Arms
« Reply #8 on: February 21, 2016, 01:41:04 AM »
The Colt Model 1911 Mk IV Series 80 is real and compensators of various types are available.



"Evil our grandsires were, our fathers worse;
And we, till now unmatched in ill,
Must leave successors more corrupted still."
Horace, 65BC - 8BC. Marsh translation.

Offline apophenia

  • Suffered two full days of rapid-fire hallucinations and yet had not a single usuable whif concept in the lot !?!
  • Patterns? What patterns?
Re: Small Arms
« Reply #9 on: February 21, 2016, 04:41:51 AM »
Did you know this?

http://www.lexikon-der-wehrmacht.de/Waffen/Bilderseitenneu/Mauser06.htm


The Gerat 06/StG45(M) prototype led to the Spanish CETME Modelo C service rifle which led to West Germany's Heckler & Koch G3.

Some MP44 whifs here: http://beyondthesprues.com/Forum/index.php?topic=351.msg103563#msg103563
Under investigation by the Committee of State Sanctioned Modelling, Alternative History and Tractor Carburettor Production for decadent counterrevolutionary behaviour.

Offline ysi_maniac

  • I will die understanding not this world
Re: Small Arms
« Reply #10 on: February 21, 2016, 05:38:52 AM »
The Colt Model 1911 Mk IV Series 80 is real and compensators of various types are available.






I am sure you know much more than me on this issue. But for me, they do not look equal: trigger guard, catch on front of slide, ... Is it just a variant?
« Last Edit: February 21, 2016, 05:53:10 AM by ysi_maniac »

Offline Volkodav

  • Counts rivits with his abacus...
  • Much older now...but procrastinating about it
Re: Small Arms
« Reply #11 on: February 21, 2016, 02:14:30 PM »
Used to own on of these (thinking of buying another at some point) which could be upgraded through buying kits quite easily to a full blown race gun for IPSC competition shooting.

Offline jcf

  • Global Moderator
  • Turn that Gila-copter down!
Re: Small Arms
« Reply #12 on: February 21, 2016, 03:02:11 PM »
I am sure you know much more than me on this issue. But for me, they do not look equal: trigger guard, catch on front of slide, ... Is it just a variant?


That's because it looks like Aoshima is flogging a poor copy of a Marui BB gun, that does look like the Colt.  8)
http://shop.ehobbyasia.com/tokyo-marui-centimeter-master-sv-ebb-pistol.html#.VslfZfh7BSU
"Evil our grandsires were, our fathers worse;
And we, till now unmatched in ill,
Must leave successors more corrupted still."
Horace, 65BC - 8BC. Marsh translation.

Offline GTX_Admin

  • Evil Administrator bent on taking over the Universe!
  • Administrator - Yep, I'm the one to blame for this place.
  • Whiffing Demi-God!
    • Beyond the Sprues
Re: Small Arms
« Reply #13 on: July 20, 2016, 03:28:49 AM »
Not sure if this qualifies as a "small" arm:  Lahti L-39 20 mm anti-tank rifle

All hail the God of Frustration!!!

Offline Jeffry Fontaine

  • Unaffiliated Independent Subversive...and the last person to go for a trip on a Mexicana dH Comet 4
  • Global Moderator
  • His stash is able to be seen from space...
    • SketchUp 3D Warehouse - My Digital Models
Re: Small Arms
« Reply #14 on: July 20, 2016, 04:07:18 AM »
Not sure if this qualifies as a "small" arm:  Lahti L-39 20 mm anti-tank rifle



FAIL!  :)

That rifle in the image you posted is not an L-39 Lahti (click on html to view image and description of this weapon at Wikipedia).

The rifle in that image is actually an Solothurn S-18/100 20mm Anti-Tank Rifle chambered to fire the 20X105B cartridge. 

The Finnish designed L-39 Lahti was chambered to fire the larger 20X138B cartridge that was also used in the Solothurn S-18/1000 (semi-auto fire only) and S-18/1100 (semi-automatic fire and full auto fire capable), Italian Breda and Scotti 20mm anti-aircraft guns as well as the German FlaK 30, FlaK 38, and C-30 20mm anti-aircraft guns. 

By the way, CMK offers that Solothrun S-18/100 in 1:35th scale as a resin accessory/detail item if you are interested. 

I picked up a couple as it is unique and unusual.  Just wish there was an injection molded plastic Solothurn S-18/1000 available in 1:35th scale.  Criel Models (Italy) used to offer one in resin but they are now OOB and it was a bit anemic looking (have two in the stash waiting to be exploited). 


***edit to fix the html and obvious sentence structure errors :(
« Last Edit: July 21, 2016, 04:53:15 AM by Jeffry Fontaine »
"Every day we hear about new studies 'revealing' what should have been obvious to sentient beings for generations; 'Research shows wolverines don't like to be teased" -- Jonah Goldberg