Author Topic: New Beginnings with a Magister  (Read 409 times)

Offline Robomog

  • Would you buy a used kit from this man?
New Beginnings with a Magister
« on: May 15, 2018, 03:35:22 AM »
Hi All
 
I finished this kit a few weeks ago and would like to share it with you as it is the second model and first aircraft I have built following my return to kit building (the first was a Bishop Tank the less said about that the better), it was chosen because it was small and simple and had less than thirty parts.

by Robomog, on Flickr


The model was from my stash circa 1979 so a cheap start to the hobby.

It was one of a number model kits I purchased when Frog went bust and they were reissued by Novo, thinking that this would be a short run and they would be worth something later on.

How wrong was I!!

The old Frog moulds are still going, only the other day I brought a Mistercraft Hunter F6 only to find it was a re-boxing of a re-boxing of a re-boxing of the original Frog mould.

So no massive killings here then.

The kit was pretty Spartan and appeared fairly good for its age with a little flash on some components the only addition being a rough and ready tab on the sprue announcing ďmade in USSRĒ, that was until I started to put it together.

As it was an open cockpit I added some extra details because they would not be hidden by a canopy. So you will see a scratch built, control panel, compass, and joystick in both cockpits.

by Robomog, on Flickr

by Robomog, on Flickr

The fuselage did not go together well, although no filler was required the fit was bad and much scraping was needed to smooth the join lines.

The main wings were equally bad and required filling all round, the tail planes were appalling the mould had really suffered here over the years and if I had fitted them as is, they would have had a markedly inaccurate forward sweep, so a few sessions of trimming and PSR was needed to get them right.

The painting took a while partly because as at this point I started building Jings! Followed by BUDD which meant this build went on the back burner for a while, also I was still getting used to painting with acrylics again so there are about three coats of brown and green and about six of yellow. I did read somewhere that yellow paint could be problematical, itís true!

The decals had not stood the test of time very well, the roundels were faded and out of register so I replaced them with spares from my stash intending to use the original serial numbers. However this was not to be. While the first underwing serial number was in soak face down I noticed a thin black stream drifting down from the paper and on inspection the whole lot had powdered and was falling off the sheet. In desperation I tried giving the remaining transfers a couple of coats of varnish but they just shattered into larger pieces.

My decal stash gave me replacements for some but they were curled and a bit suspect so I had to bite the bullet and purchase some new numbers to finish it off, so much for a cheap starter kit. As it turned out some of the decals on the sheets I bought were still too big so I had to use the old sheets anyway and my worst fears were realised. The letters on the outside edges were fine but the ones in the middle were damaged so between both sheets I had six Sís and I managed to complete the serial on both wings with one S to spare!

A few more shots of the finished project, itís not perfect but in my eyes, acceptable.

by Robomog, on Flickr

by Robomog, on Flickr

by Robomog, on Flickr

by Robomog, on Flickr

by Robomog, on Flickr


As always any comments or criticisms gratefully received.

Mog
>^-.-^<
« Last Edit: May 15, 2018, 03:38:09 AM by Robomog »

Offline GTX_Admin

  • Evil Administrator bent on taking over the Universe!
  • Administrator - Yep, I'm the one to blame for this place.
  • Whiffing Demi-God!
    • Beyond the Sprues
Re: New Beginnings with a Magister
« Reply #1 on: May 15, 2018, 04:05:33 AM »
 :smiley:
All hail the God of Frustration!!!

Offline apophenia

  • Suffered two full days of rapid-fire hallucinations and yet had not a single usuable whif concept in the lot !?!
  • Patterns? What patterns?
Re: New Beginnings with a Magister
« Reply #2 on: May 15, 2018, 04:22:55 AM »
Obviously plenty of challenges there ... but well worth it. A lovely build of a oft-neglected subject  :smiley:
Under investigation by the Committee of State Sanctioned Modelling, Alternative History and Tractor Carburettor Production for decadent counterrevolutionary behaviour.

Offline Brian da Basher

  • He has an unnatural attraction to Spats...and a growing fascination with airships!
  • Global Moderator
  • Hulk smash, Brian bash
Re: New Beginnings with a Magister
« Reply #3 on: May 15, 2018, 04:36:15 AM »
Wow that's most impressive for only your second model since returning to building again, Mog!

I wouldn't have a clue about the codes if you hadn't mentioned it.

Speaking of mentions, you deserve an honorable one for the great paint work! Yellow is always a challenge and your finish is very nice indeed.

The added details are a treat!

Well done!

Brian da Basher

Offline Robomog

  • Would you buy a used kit from this man?
Re: New Beginnings with a Magister
« Reply #4 on: May 19, 2018, 04:34:40 AM »
Thanks for the kind comments guys, much appreciated

Mog
>^-.-^<

Offline Camthalion

  • The man has done a pink tank...need we say more?!
Re: New Beginnings with a Magister
« Reply #5 on: May 21, 2018, 11:05:44 PM »
very nice

Offline Robomog

  • Would you buy a used kit from this man?
Re: New Beginnings with a Magister
« Reply #6 on: May 23, 2018, 08:57:55 PM »
Thanks Camthalion

Mog
>^-.-^<