Author Topic: B-25 Mitchell In SEAC markings  (Read 442 times)

Offline Robomog

  • ...had a very bad experience with [an] orange...
  • Would you buy a used kit from this man?
B-25 Mitchell In SEAC markings
« on: March 24, 2026, 08:04:22 AM »
Hi All

Between working on the Stirling, finishing the diorama and completing the Tilly I've started another build as a between builds filler.

I'm using the Vintage FROG B-25 mitchell  circa 1964  as the subject  in its original box its probably a sought after collectors piece, but as a collection of pieces, some dodgy decals and the original instructions I think it's fair game.



There are a few sink holes but on the whole it seems to be in good condition, detailing is minimalist but I like that in a kit.
I have some spare bits from an Airfix Mitchell but I probably won't need them.

The instructions are quite interesting



I'm going to put it in SEAC markings from an Xtradecal sheet, lots of choice on this but I've gone for the pretty Oxford Blue paint scheme not sure if it's a gloss or matt finish.



More when it happens......

Mog
>^-.-^<

Mostly Harmless...............

Offline Robomog

  • ...had a very bad experience with [an] orange...
  • Would you buy a used kit from this man?
Re: B-25 Mitchell In SEAC markings
« Reply #1 on: March 27, 2026, 08:23:48 AM »
Hi All

And now it begins........

The previous modeller had already started the interior paintwork which looked fine to me, so first job is to mask and install the windows.



The pilots had already been painted so I made the decision to use them as well, I don't usually include the pilots  seem a shame to waste a good paint job.

The cockpit is a bit sparse so I added a control panel and some instrumentation, also made a couple of control yokes out of fuse wire



This aircraft is unarmed so I removed  the turret support ring, the seat stays however because this becomes an observation station, I will need to find  a clear dome to go over the top or manufacture one. Unfortunately the turret is insufficient.



Found a problem with the nose glazing, a glue patch, I tried to Buff it out but it go's all the way through. I'll have to do some ' local modifications '  a bit further down the line.



Thanks for looking ..........

Mog
>^-.-^<

Mostly Harmless...............

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: B-25 Mitchell In SEAC markings
« Reply #2 on: March 27, 2026, 09:21:25 AM »
Great to see more "old gold" builds.

Even more to see the Frog "Mutt and Jeff" pilots getting a run  :smiley:

Offline Old Wombat

  • "We'll see when I've finished whether I'm showing off or simply embarrassing myself."
  • "Define 'interesting'?"
Re: B-25 Mitchell In SEAC markings
« Reply #3 on: March 27, 2026, 04:12:37 PM »
Referring, of course, to Joseph Summers and Jeffrey Quill.

With the exception of Eric Brown, I can't think of two better pilots to be flying a plane if I was a crew member.

 ;)
"This is the Captain. We have a little problem with our entry sequence, so we may experience some slight turbulence and, ah, explode."

Offline Robomog

  • ...had a very bad experience with [an] orange...
  • Would you buy a used kit from this man?
Re: B-25 Mitchell In SEAC markings
« Reply #4 on: March 28, 2026, 02:25:40 AM »
Thanks chaps, a bit more progress.

The fuselage has been closed up



And the wings have also been started, this is one of those annoying kits that requires you to install the undercarriage early in the build, but fortunately if you don't glue the joints you can retract it out of the way



The wings are on, for an old kit the parts fit remarkably well, there is some filling to be done there's a lot of sink holes, but nothing like the Sterling that is a younger kit



More when it happens......

Mog
>^-.-^<
Mostly Harmless...............

Offline Robomog

  • ...had a very bad experience with [an] orange...
  • Would you buy a used kit from this man?
Re: B-25 Mitchell In SEAC markings
« Reply #5 on: Yesterday at 07:07:55 PM »
Hi all

Things are moving quite fast now, bracing myself for somthing to screw things up.

All assembled........



All masked and a coat of primer applied leading to  some more tidying up of sink holes and join lines....



First coat of paint, a moody Oxford Blue....



Thanks for looking....


Mog
>^-.-^<
Mostly Harmless...............

Offline Kerick

  • Reportedly finished with a stripper...
Re: B-25 Mitchell In SEAC markings
« Reply #6 on: Yesterday at 11:38:19 PM »
That’s a nice look for the old Mitchell! Carry on!

Offline Frank3k

  • Excession
  • Global Moderator
  • Formerly Frank2056. New upgrade!
    • My new webpage
Re: B-25 Mitchell In SEAC markings
« Reply #7 on: Today at 04:09:50 AM »
Looks great for such an ancient kit - the blue looks gorgeous.

I thought this was a reboxing of the old Airfix B-25, but it seems to have been an original mold. No massive rivets to deal with, from the looks of it.

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: B-25 Mitchell In SEAC markings
« Reply #8 on: Today at 04:43:59 AM »
Things are moving quite fast now, bracing myself for somthing to screw things up.

it is an old kit from simpler times, getting them together was meant to be a weekend job, not 800 parts and a Pontifical High Mass.  ;)

Offline Robomog

  • ...had a very bad experience with [an] orange...
  • Would you buy a used kit from this man?
Re: B-25 Mitchell In SEAC markings
« Reply #9 on: Today at 05:28:04 AM »
Thanks chaps

The part count is quite low, no rivets and minimal raised panel lines.

What's not to like ?  ;)

Mog
>^-.-^<
Mostly Harmless...............