« previous next »
Pages: [1]   Go Down

Author Topic: '46 German E25 - 1/35  (Read 13590 times)

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
'46 German E25 - 1/35
« on: July 08, 2024, 01:31:02 PM »
Hmmm what to do, what to do ?
Pulled a few kits out, put most back.
Then went to this, the Trumpeter E25


.. 2 hours later.
Pretty simple build, all out of the box so far. You get the option of roof for either the small turret or just hatches. As if the just hatches option was ever going to happen  ;)


Currently on the tracks, you get the option of rubber bands or individual links.. Yes.. I went the indi links, but they almost got tossed in the box when I saw that each link had two knock out pin blemishes, that need attention. But, I persevered as there were only 72 links a side. So work continues
« Last Edit: July 08, 2024, 01:37:23 PM by Buzzbomb »
Logged

Offline Claymore

  • It's all done with smoke and mirrors!
  • Alt Hist AFV guy with a thing for Bradley turrets
Re: '46 German E25 - 1/35
« Reply #1 on: July 08, 2024, 02:56:49 PM »
I wonder where this one is going!  :smiley:
Logged
Pass the razor saw, there is work to be done!

Offline Old Wombat

  • "We'll see when I've finished whether I'm showing off or simply embarrassing myself."
  • "Define 'interesting'?"
Re: '46 German E25 - 1/35
« Reply #2 on: July 08, 2024, 11:29:19 PM »
Seriously tortoise-like! ;D
Logged
"This is the Captain. We have a little problem with our engine sequence, so we may experience some slight turbulence and, ah, explode."

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: '46 German E25 - 1/35
« Reply #3 on: July 09, 2024, 03:11:42 PM »
Quote from: Claymore on July 08, 2024, 02:56:49 PM
I wonder where this one is going!  :smiley:

Well it started out going completely out of the box... then I had a yeah,nahh moment and off we headed down the whiffing the whiff path

Ditch the gun, 3d print the basis of a new mantlet and do a roof mounted Range Finder setup. Now heading off to be an Artillery Observation platform, like a retro version of the AO vehicle based on the Jaguar Anti Tank Missile platform.
Being rather small and perhaps nippy it would maybe make a fine E Series Artillery Observation vehicle.



The mantlet will probably have some scissor Binoculars in a rotating mount, I you have space, may as well use it. Plus it will get a workover to get rid of the print marks.

Logged

Offline Claymore

  • It's all done with smoke and mirrors!
  • Alt Hist AFV guy with a thing for Bradley turrets
Re: '46 German E25 - 1/35
« Reply #4 on: July 09, 2024, 03:34:35 PM »
Nice!  :smiley:
Logged
Pass the razor saw, there is work to be done!

Offline Mig Eater

  • Munch, Munch, Munch
    • Mig Eater Studio
Re: '46 German E25 - 1/35
« Reply #5 on: July 09, 2024, 06:34:52 PM »
The E-25 is one of my favorite tanks and underrated when it comes to whifing IMO, looking forward to seeing how you AOP concept unfolds. 
Logged

Offline Frank3k

  • Excession
  • Global Moderator
  • Formerly Frank2056. New upgrade!
    • My new webpage
Re: '46 German E25 - 1/35
« Reply #6 on: July 09, 2024, 11:06:11 PM »
It looks good! I built the E-10 version years ago as a French tank with a Gatling gun.

Is that cover in PLA or ABS? If ABS, you can smooth it (carefully) with Acetone. You could also leave it as a forward radar to track rounds or something.
Logged

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: '46 German E25 - 1/35
« Reply #7 on: July 11, 2024, 07:16:49 AM »
Quote from: Frank3k on July 09, 2024, 11:06:11 PM
It looks good! I built the E-10 version years ago as a French tank with a Gatling gun.

Is that cover in PLA or ABS? If ABS, you can smooth it (carefully) with Acetone. You could also leave it as a forward radar to track rounds or something.

PLA.. just doing this sort of thing for cast texture. Never had much luck with the Acetone fume smoothing, it either blobbed or did nothing of any consequence to smooth it off.


The good thing about progress photos is you can see what might not work. Looking at the photos, front mount location for the rangefinder does not work efficiently.
So, after I took all the temp placements off to work on the mantlet/casement and work around options for the range finder, I came to the conclusion around maybe working up a solution using the turret /turret location.

Or ditch the lot and just go back to out of the box.
Logged

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: '46 German E25 - 1/35
« Reply #8 on: July 13, 2024, 03:47:35 PM »
Right then.
Some reworking/redesign around bits that did not work during the experimental phase.
Moved the range finder to replace the MG in the turret because :-
a. fire from the MG would have hit it
b. a tad higher and more flexible.
c. If you really want to, you could also say that it could be extended upward by maybe half a metre or so.
Replaced the MG with a Hetzer type Remote MG. And yes.. the Rangefinder LOS does clear the MG Mount ;)

Scissor Binocular mount added over the Casement blanking casting


Overhead view, the boxes on the back of the turret are counter weights. The remote MG also has more ammo via a transverse ammo box below the gun. Normally these would
tend to use the 50 round circular magazines. Brass grilles are only tacked on at the moment until I finish faffing about. Plus the wandering vent has yet another home.


Maybe a bit more tinkering then to the paint shop/procrastination phase


Logged

Offline Claymore

  • It's all done with smoke and mirrors!
  • Alt Hist AFV guy with a thing for Bradley turrets
Re: '46 German E25 - 1/35
« Reply #9 on: July 13, 2024, 06:24:12 PM »
Looking good and a much better location for the primary range-finder, IMHO.  :smiley: :smiley:
Logged
Pass the razor saw, there is work to be done!

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: '46 German E25 - 1/35
« Reply #10 on: July 19, 2024, 08:19:05 AM »
So before I disappear for a weekend of modelling mayhem at our club Build weekend/Modellers retreat... an update.

We are out of the paint shop and have decals (exactly 2  ;) ) put on. Next stop.. the weathering booth






Logged

Offline GTX_Admin

  • Evil Administrator bent on taking over the Universe!
  • Administrator - Yep, I'm the one to blame for this place.
  • Whiffing Demi-God!
    • Beyond the Sprues
Re: '46 German E25 - 1/35
« Reply #11 on: July 19, 2024, 08:31:05 AM »
 :smiley:
Logged
All hail the God of Frustration!!!

You can't outrun Death forever.
But you can make the Bastard work for it.

Offline Frank3k

  • Excession
  • Global Moderator
  • Formerly Frank2056. New upgrade!
    • My new webpage
Re: '46 German E25 - 1/35
« Reply #12 on: July 19, 2024, 10:32:00 AM »
wow! Great camo pattern!
Logged

Offline Old Wombat

  • "We'll see when I've finished whether I'm showing off or simply embarrassing myself."
  • "Define 'interesting'?"
Re: '46 German E25 - 1/35
« Reply #13 on: July 19, 2024, 01:12:28 PM »
Ooh! Nice! 8)
Logged
"This is the Captain. We have a little problem with our engine sequence, so we may experience some slight turbulence and, ah, explode."

Offline Mig Eater

  • Munch, Munch, Munch
    • Mig Eater Studio
Re: '46 German E25 - 1/35
« Reply #14 on: July 19, 2024, 06:53:38 PM »
Really clean looking camo  :smiley:
Logged

Offline Buzzbomb

  • Low Concentration Span, oft wanders betwixt projects
  • Accurate Scale representations of fictional stuff
    • Club and my stuff site
Re: '46 German E25 - 1/35
« Reply #15 on: July 30, 2024, 02:29:39 PM »
Thanks team.

Got to the "that will do" stage. It is now on the shelf








Logged

Offline Old Wombat

  • "We'll see when I've finished whether I'm showing off or simply embarrassing myself."
  • "Define 'interesting'?"
Re: '46 German E25 - 1/35
« Reply #16 on: July 30, 2024, 05:17:37 PM »
Yep: That'll do, Donkey! That'll do! ;)

Excellent finish, BT! :smiley: :smiley:
Logged
"This is the Captain. We have a little problem with our engine sequence, so we may experience some slight turbulence and, ah, explode."

Offline Mig Eater

  • Munch, Munch, Munch
    • Mig Eater Studio
Re: '46 German E25 - 1/35
« Reply #17 on: July 30, 2024, 08:03:32 PM »
Nice  :smiley:
Logged

Offline Claymore

  • It's all done with smoke and mirrors!
  • Alt Hist AFV guy with a thing for Bradley turrets
Re: '46 German E25 - 1/35
« Reply #18 on: July 30, 2024, 08:51:59 PM »
A really interesting (and different) subject, superbly executed. Sweet as a carrot - as was the epitome of excellence at my old training depot in East Anglia!  :smiley: ;D :smiley:
Logged
Pass the razor saw, there is work to be done!

Offline Frank3k

  • Excession
  • Global Moderator
  • Formerly Frank2056. New upgrade!
    • My new webpage
Re: '46 German E25 - 1/35
« Reply #19 on: July 31, 2024, 01:06:05 AM »
That came out great! Nice, subtle weathering, too.
Logged

Offline taiidantomcat

  • Plastic Origamist...and not too shabby with the painting either!
  • Full Member
  • Stylishly late...because he was reading comics
Re: '46 German E25 - 1/35
« Reply #20 on: August 18, 2024, 06:17:49 AM »
Impressive and dare I say "Cute"?

its interesting seeing 3d parts appear more and more often in a more regular way. Its still "exotic" in my mind but I listened to some modeling podcasts and they speak about it as casually as airbrushing.
Logged
"They know you can do anything, So the question is, what don't you do?"

-David Fincher

Offline raafif

  • Is formally accused of doing nasty things to DC-3s...and officially our first whiffing zombie
  • Whiffing Insane
Re: '46 German E25 - 1/35
« Reply #21 on: August 18, 2024, 08:21:31 AM »
Quote from: Buzzbomb on July 30, 2024, 02:29:39 PM
Thanks team.






Good change in lighting -  I think I prefer the "faded" bottom pic - with the purple-brown (WW1 aircraft) colour :smiley:
Logged
Pages: [1]   Go Up
« previous next »