General Category > Support Products

Looking for decals

<< < (5/7) > >>

Frank3k:
If those are old ESCI decals coat them in Future, Klear, etc. before use. Otherwise, you're going to have a bad time. The decals will disintegrate when placed in water; the clear coating will hold them together long enough to transfer. Actually, that's always good advice for decals of unknown pedigree/age.

GTX_Admin:
Does anyone produce low viz Israeli or Singaporean Roundels in either 1/72 or 1/48?

deathjester:

--- Quote from: Jeffry Fontaine on December 25, 2012, 10:35:41 AM ---
--- Quote from: elmayerle on December 24, 2012, 02:30:59 AM ---Still digging, but I know I've got the 1963-1970 and 1970-1980 roundels in 1/72 from an Xtradecal set on International Hunters (also have 'em in 1/144).  I'm still checking to see what I have in 1/48.
--- End quote ---

--- Quote from: elmayerle on December 25, 2012, 02:09:41 AM ---Okay, I've got a Cutting Edge Hunter sheet that has the 1963-1970 roundels in 1/48.  Which of the sets I have best suit your needs?
--- End quote ---

Hi Evan,

I think the 1:48th scale 1963-1970 roundels will be the best choice.  If memory serves me these roundels were not overly large to begin with so anything smaller would probably not be practical. 

Thanks again for helping out.  Had no clue RhAF markings would be such a challenge to source.

--- End quote ---
Are you still after Rhodesian AF decals?

Jeffry Fontaine:

--- Quote from: deathjester on April 24, 2018, 06:44:51 PM ---Are you still after Rhodesian AF decals?
--- End quote ---
I could certainly use a few more roundels if you have them to spare. 

Thanks

elmayerle:
I wouldn't mind picking up a few, either.

Navigation

[0] Message Index

[#] Next page

[*] Previous page