Hi All
Here is an easy way to manufacture internal bulkheads to fit inside a fuselage.
This is not my original idea I'm pretty sure I picked this up from somewhere on the interwebs but I can't for the life of me remember where. Perhaps one of you guy will put me straight. I just want to pass on the technique.
First get some fuse wire and mould it to the inside of the fuselage.......
by
Robomog, on Flickr
Next .......
Place on a piece of plastic card and trace round the outside of the wire.......
by
Robomog, on Flickr
Then.........
Carefully line it up and trace the other side. Obviously if the two sides are different make another profile
by
Robomog, on Flickr
Finally.......
Carefully cut it out and adjust to fit
by
Robomog, on Flickr
Errrm....
yes well not the best fit but you get the picture, using a finer wire than I've use here will give you a better profile and taping the wire down will make it easier to trace.
Hope you find this useful
Mog
>^-.-^<