Modelling > Other
Just some cool photos...nothing more, nothing less...
The Big Gimper:
Really USMC?
On April 24, 2024, a CH-53K transported an F-35C, tail number CF-01, from its storage site Naval Air Station Patuxent River, Maryland, to to a Navy unit located at Joint Base McGuire-Dix-Lakehurst, New Jersey.
Kerick:
Maryland to New Jersey isn’t very far and good training opportunity. Or just to prove it can be done!
The Big Gimper:
The Curtiss-Wright AT-9 Jeep was an American twin-engined advanced trainer aircraft used by the United States during World War II to bridge the gap between single-engined trainers and twin-engined combat aircraft. The AT-9 had a low-wing cantilever monoplane configuration, retractable landing gear and was powered by two Lycoming R-680-9 radial engines.
Curtiss-Wright anticipated the requirement for this type of "high-performance" aircraft and designed the Curtiss-Wright CW-25, a twin-engined trainer, which possessed the takeoff and landing characteristics of a light bomber. Using the same basic design as the larger Cessna AT-17 Bobcat, the new CW-25 was designed to simulate the demands of multi-engined operations.
The design featured a small layout, grouping two Lycoming R-680-9 radial engines forward and using a retractable tailwheel landing gear to achieve the performance necessary to meet the requirements of an advanced trainer. The single CW-25 prototype acquired for evaluation had a welded steel-tube fuselage structure with the wings, fuselage and tail unit fabric-covered.
The first prototype Model 25 flew in 1941 and the production version entered service as the AT-9 in 1942. Named the "Fledgling" by Curtiss-Wright, it commonly became known as the "Jeep" in the United States Army Air Forces (USAAF). The prototype CW-25 had a fabric-covered steel tube fuselage and fabric-covered wings and tail units, but production AT-9s were of stressed metal skin construction.
The AT-9 was purposely designed to be less stable and proved to be difficult to fly or land, which made it particularly suitable for teaching new pilots to cope with the demanding flight characteristics of a new generation of high-performance, multi-engined aircraft such as the Martin B-26 Marauder and Lockheed P-38 Lightning.
Note: I did not know this.
A total of 491 AT-9s were built before production ended and a new production run of 300 of the generally similar AT-9A commenced.
Because of its difficult flying characteristics the AT-9 was not offered for sale to civilians after the war, although many non-flying examples were given to ground schools for training purposes.
Two aircraft survive today:
41-12150 – AT-9 on static display at the National Museum of the United States Air Force in Dayton, Ohio. It required extensive restoration, and was the product of the museum staff incorporating two incomplete airframes together, along with parts fabricated on site.
42-56882 – AT-9 in storage at the Pima Air & Space Museum in Tucson, Arizona. It was recovered from a crash site in 1993 and turned over to the museum for restoration. However, the aircraft is incomplete and will require a long and extensive restoration for display.
elmayerle:
--- Quote from: The Big Gimper on April 27, 2024, 12:18:09 AM ---Really USMC?
On April 24, 2024, a CH-53K transported an F-35C, tail number CF-01, from its storage site Naval Air Station Patuxent River, Maryland, to to a Navy unit located at Joint Base McGuire-Dix-Lakehurst, New Jersey.
--- End quote ---
CF-01 was the first "C" model and served as a aerodynaic testbed without radar or a number of other pieces of operational equipment. It should make a suitable display aircraft.
The Big Gimper:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version