Author Topic: Panther tank "What If" aka Zombie Reaper  (Read 907 times)

Offline tankmodeler

  • Wisely picking parts of the real universe 2 ignore
Re: Panther tank "What If" aka Zombie Reaper
« Reply #15 on: September 20, 2018, 01:33:37 AM »
You could do something similar by cutting out two circles in styrene, tacking them together with white glue (or a touch of CA - you don't want a permanent joint) and sanding the two circles round and equal. Then drill holes through both, slowly increasing the hole sizes until they match your barrel diameter. Then separate and build the gun.

^^^ This is what to do.

Offline Gingie

  • The LAV sausage-maker…goes nice with a home made beer I understand
  • Has been to Tatooine...
Re: Panther tank "What If" aka Zombie Reaper
« Reply #16 on: September 24, 2018, 12:35:06 AM »
Slow but steady process.

I've hit a roadblock on scratching the 35mm Gatling Gun



Looking for something that can be used for above circular barrel supports (? correct terminology?)

Apart from cutting the supports from styrene couldn't find something suitable ?!

Any suggestions ?

Ta for making BtS so great

I used a pair of 8 x bolt pattern wheel rims and drilled out the bolts...