A lot less PSR than expected!

Just sprayed some black into the wheel wells & around the Putty-Sand area & there is only a little "r" to finish it off, & that is really only a touch more "s".
After that I need to get the turrets in, & the cockpit glazing on, so I can start the camo. This is a problem as it would be easier to paint the plane without the turrets. However, if I do that, there are parts that need to be fitted after the turrets are in to secure them in place & these, I'm sure, will need a certain amount of PSR to get to fit properly.
Plus all that masking!

Plus the turrets need a bucket-load of work to get them ready to fit because, of course, I'm modifying them, aren't I.
