Hi Simon,
There is a moment I wanted to scratch one but no documentation à this moment and I couldn't do the CAD Model to make the plans. Recently I saw again SG-1/SGA (all of them) and, this idea came back. This time, I have doc and I made the 3D model in about 2-3 evenings
Finally, I started the build after I saw your comment and for the moment, it's easiest than I tought (it's my first full scratch model).
Only need :
- Styrene sheet
- ruler/square
- pencil
- cutter
- millimeter paper
- Tamya styrene glue
- plans (of course)
If you want, I can send you my plans in pdf format ready to print in A4 for a 1/1000th model
They're not finish, I do them when I need one. For the moment, I only print the one which are upper so this one is ready.