Got the nacelles done and glued on (top pic). Before I did that I painted the inside of the air intakes and the face of the compressors. In the second pic which I'm posting again, you can see the small triangular parts in front of the engines, I painted the inside side of them which is the side you see. These parts are turned upside down and fit into the triangular opening on the engine with the round bit up against the compressor face (third pic). However, once the lower front of the nacelles are in place you can see about naff all ----- (bottom pic). Also in the bottom pic you can see a radiator duct on the bottom of the nacelles, you have to add a small part which is the radiator before the nacelles side get glued together and is about half way down the intake, something else you're just not going to see when it's all built up. There is a lot of flash around the intake of this duct and on the exit end, maybe once I clean it all up something will be visible ---
The four nacelles are almost identical, the #1 nacelle and the #4 nacelle are interchangeable, the #2 and #3 nacelles are different slightly and also different to each other. That's because on the outer side of these inner nacelles it has what looks like a bit of armour plate which is inline with the outer nacelle propellers. I think I'm going to add something similar to the fuselage sides when I get that far ahead. I used to see something like it on the sides of the Q400's at YYC