Since we extended the GB time frame, time to get another one done.
Being totally on the Zombie Theme, this time one of the protagonists.
Found this on Thingiverse, the whole concept of walking on the hands tweaked my interest
Now, as some of you know what the design looks like and what the earlier ABS printers can do as far as quality is very often lightyears apart.
This is the print, done in fine mode directly off the printer, but enough to work with as it mostly turned out ok
Quite a few bits where the .STL file did not produce what was on the brochure
with ill defined features and some random print lines
Dremel time with a carving bit and hack away. I figure it is a Zombie so imperfections on the flesh are not that critical, plus it I was not too fussed about being super finished
Then it was PSR time.
More to follow