Hi all
Apologies. Haven't been in a good place recently, hence the lack of posts, rectifying that now with a progress update
The grab is now complete.
Top.........
by
Robomog, on Flickr
Bottom.......
by
Robomog, on Flickr
As you can see it will now support it's own weight quite happily, big shout out to
tankmodeler for the PVA tip, it worked a treat.
I'm not going to enhance this with any decals, I think its detailed enough.
The main body is ready for its Decals, as is the Escape Pod
by
Robomog, on Flickr
I have decided to leave the burner cans a shiny chrome finish, the decals have been printed, I'm leaving them a couple of days to dry thoroughly before the varnish coat is applied.
On the pod I have changed my mind on having the rotating side boosters, I'm going to opt for a small angled burner can instead to make the design more compact
The next post should be the finished article...........
Thanks for looking.
Mog
>^-.-^<