I'm a bit a bit late to this GB, but I'm hoping to get this finished in time . . .
I didn't think I had anything suitable, then I remembered I'd bought this kit to replace the Pegasus kit I'd already built, then I found that I had some sharkmouth decals on a sheet I'd bought for another project . . .
So, off we go !
Here's the Box Art,
![](https://i.postimg.cc/GcLFWKM5/00-box.jpg)
I think Curtiss Hawk style teeth will look good on this, especially as I'll be using an alternative scheme where the fuselage is pale blue . . .
The sprue, such that it is.
![](https://i.postimg.cc/HHqQYdZ5/00-sprue.jpg)
It's a simple build, but has the complication that the engine must be finished before the fuselage halves can be assembled. So here's the engine glued to the cockpit floor.
![](https://i.postimg.cc/XVsf45m7/00-engine-glued.jpg)
With that done, I looked at the wings. As per my previous build, they're going to be fitted in the mid position, so need to be cut in two. Here are the wings before,
![](https://i.postimg.cc/2YXQt4n0/00-wings.jpg)
and after cutting.
![](https://i.postimg.cc/DvD1bT79/00-wings-cut.jpg)
Lastly for this time, I removed the lower wings from the lower centre-section, again before,
![](https://i.postimg.cc/R967xNR4/00-lower-wings.jpg)
and after,
![](https://i.postimg.cc/4fnzddRv/00-lower-cs-cut.jpg)
this part will be attached to the asembled fuselage and faired to shape.
That's All For Now, Stay Tuned . . .
cheers,
Robin.