General Category > Looking for Kits, Parts, and Decals

Unicorns & Holy Grails

<< < (7/9) > >>

Frank3k:
I have a Rhino3D (unfinished) design for 1/350 models of both the Pegasus (similar to the Ithacus, but smaller) and Hyperion based on the drawings in "Frontiers of Space" by Bono & Gatland. I haven't worked on it in a while, because the 3D prints would have been very expensive. Maybe I'll get back to them. I wish Allan would have picked 1/350 instead of 1/288

GTX_Admin:
Indeed.  1/350 could allow for easy modelling onto ships of the same scale:



Am aware of Pegasus & Hyperion too:

Frank3k:
One issue that I had with the design of the Pegasus was the gear. I just couldn't get it to look right in 3D, compared to the drawings. Same with the Hyperion. It looks like Nick Stevens ran into the same issues!

kitnut617:
So the Ithacus would be 36" tall in 1/72, about the same as the Shuttle on the external tank

Frank3k:
In 1/350 it would be 183mm (7.5")tall x 69mm (2.7") in diameter.

Navigation

[0] Message Index

[#] Next page

[*] Previous page