The two together look like they could also be a radome of some sort. You'd probably need a faired support to mount it on top of or below an aircraft of your choice or fair it into the fuselage the way the "M&M" radome is faired into the bottom of the EP-3E and raised/lowered from the former weapons bay.
Turning a pair of these into a radome might work. Size of these tanks glued together is slightly less than the radome found on the Shackleton, Avenger, Guardian, PB1W Flying Fortress in regards to width but the length is much greater. With several of the Grumman Guardian kits in the stash and a couple of the old ESCI AD4W Skyraider AEW kits I am flush with radomes for that period/era of aviation.
<snip>regarding your A-20 drop tank question, I suppose you could fashion a nice swimmer delivery vehicle from those.
Some fins, shrouded prop, some thingamabob for a control co sole and two Navy SEALs from a Dragon kit.
Funny that you should mention that bit about fins. I did take a look at what I had in the parts bin for fins that would look appropriate for a pair of those tanks glued together. So far nothing I have checked looks right. As a submarine shape, now that might be interesting to take up, length is about the same as a 1:700 Jimmy Carter and it is about four typhoons in beam. Rather portly looking but might make an excellent submarine tanker or perhaps a SDV in 1:72nd scale. A lot of tiny bits would be needed to give it the right features, not sure I want to spend that much time on something not 1:48th or 1:35th scale but if anyone else feels up for the challenge I would be happy to send them a pair of tanks so they could make it happen.
A 1/48 drop tank with suitable bits from a 1/35 Willys Jeep. ![Grin ;D](http://beyondthesprues.com/Forum/Smileys/clabIcons/grin.gif)
You might be on to something with that suggestion Mortiz. I will not do that but if someone else is interested, I can always send them a couple of tanks to try out.
It's great to see you back having fun with plastic again, Mr Fontaine!
I think drop tanks are some of the most useful spare parts. The halves can be used for tinted canopies, air scoops, engine or landing gear fairings and as Our Resident Engineer said, radomes. I like your life raft canister idea too.
Whole drop tanks make great engine fairings (like those for a Fokker or Ford tri-motor) in 1/72 scale or power eggs (just attach prop and pipes) in 1/144. Also you can make bombs by attaching fins (hello Bill!) cut from card.
HTH,
Brian da Basher
Thanks for the encouragement Brian, it is hard to find time to build even with all of the time in the world on my hands, it mostly comes down to being in the mood to model. Granted the ongoing saga of sorting through all of the model parts accumulated over the years is a bit daunting and leads to a feeling of despair at times, I can often bounce out of that if I start putting plastic in my hands for the purpose of building something.
As for ideas, I think Moritz has a great suggestion for turning a pair of the tanks into a buggy of some kind and the submersible/submarine.
Other ideas I have had are to consider the idea of huge wing tip fuel tanks (like those seen on early marks of Lockheed Neptunes) or as a gondola under the fuselage holding a large cannon of some kind (Henschel Hs-129). The gun gondola might be the one with less effort as all you need to do is poke a hole in the front of the thing and stick in a gun barrel. The fuel tank idea may work if you can get all four tanks to be as close to identical after sanding the external features off the surfaces. That was one thing that really surprised me on the one set of tanks sanded smooth in the original post. The engraved features were still there after all the sanding I did, kind of frustrating to be honest.