Found this Card type model on Thingiverse and the images made it look more 3 dimensional than most Card models
https://www.thingiverse.com/thing:6507750 There are other options on there as well, but this tweaked my interest.
My first couple of attempts to get it to print failed, for various reasons, so I got a buddy to check print and this is his run, in black, which sucks a lot as far as photos go. This run is also in low res.
![](https://www.dropbox.com/scl/fi/i2pdxcea29reynw1b49m8/Ornithopter_1.JPG?rlkey=hbwplzv6s36nmrtijcfzgfrc7&st=cxcorw8x&raw=1)
Some instructions are provided at the original Printable posting and these, well guidelines and fairly loose at that. So went at it and it really did not take that long.
I did find that the location slots and/or the tabs needed some filing/sanding in almost every case. Once done the guidelines get you on the way
![](https://www.dropbox.com/scl/fi/xgp92m0vo8382n3wo8n0g/Ornithopter_2.JPG?rlkey=c3gs2sjqhg0yg5753f3l5w6lx&st=3dtumqjw&raw=1)
Construction done
![](https://www.dropbox.com/scl/fi/ttnhpm08tp1b223jt3dri/Ornithopter_3.JPG?rlkey=2y6qz2q1bwt9yektp0o7qfq9x&st=w2hgciso&raw=1)
![](https://www.dropbox.com/scl/fi/2pb9a2iusyq7hn69q0tik/Ornithopter_4.JPG?rlkey=bpfz4p93mvmg4if07zrvzh1h5&st=twn0bcog&raw=1)
![](https://www.dropbox.com/scl/fi/mpyf5t14xe7njfq0l4nea/Ornithopter_5.JPG?rlkey=q4yo60rpfhf0gegjkiw44gmoj&st=wr1vj4od&raw=1)
I might try and print again in a finer mode and then continue it through. With a bit of work and extra detailing up, this could possibly turn out alright.
This scales out to around 1/72 I reckon